Fence Renovation Cost: Repair, Restore or Replace?

Fence renovation cost in 2026 runs from about $250 to $750 for a typical repair, $4 to $14 per linear foot to clean and re-stain, and $20 to $60 per linear foot to replace a 6-foot wood fence. So the real question is not just price. Instead, it is which of the three jobs your fence actually needs.

This guide walks through each option, shows what it costs, and gives you a simple rule for deciding. In addition, there is a worked example for a 150-foot backyard fence, so you can see how the numbers stack up.

Fence Cost Calculator

Enter your fence length, material and gates for a 2026 installed price range, adjusted for your zip code.

ft

A typical backyard needs 150 to 200 ft. One acre is about 835 ft around.

gates
gates

Sets local labor rates.

Estimated fence cost

$4,000 – $9,800

Typical: $6,900

Using national average prices. Add your zip code for local prices.

  • Fence, installed$3,800 – $9,000
  • Gates$200 – $800
  • Confirm your property line before building. A survey costs far less than moving a fence.
  • Call 811 a few days before digging post holes so buried utility lines can be marked.

Fence renovation cost at a glance

Wood privacy fence that may need repair, restoring or replacement, shown to explain fence renovation cost

“Renovation” can mean three very different jobs. First, you can repair the broken parts and leave the rest alone. Second, you can restore the whole fence by cleaning it, fixing it and putting on fresh stain. Third, you can tear it out and start over.

The table below sets out typical 2026 prices for each route. However, your own quote will depend on fence length, height, material, access and local labor rates.

Renovation option What it usually covers Typical 2026 cost
Spot repair A few boards, a panel, a gate or one or two posts $250 to $750 per job
Post replacement Dig out a rotted or broken post and set a new one $120 to $400 per post
Restore (wash + stain) Pressure wash, then stain or seal one side $4 to $14 per linear foot, plus washing
Pressure washing only Clean off dirt, mildew and gray weathering $0.10 to $0.50 per sq. ft.
Old fence removal Tear out and haul away the old fence $4 to $10 per linear foot
Full replacement (wood, 6 ft) New posts, rails and boards, installed $20 to $60 per linear foot

Source: Fence Guides 2026 rate sheet, checked against HomeGuide and Angi. Staining and washing figures from Angi.

Option 1: Repair what is broken

Repair is the cheapest route when the damage is local. For example, a storm might knock down one section, or a single post might rot at ground level. In that case, a fence company or handyman fixes that spot and the rest of the fence carries on.

Most single repairs land between $250 and $750. Still, the material matters. Here is what we use across the site for 2026:

  • Wood: $130 to $600 per repair
  • Vinyl: $250 to $800 per repair
  • Chain link: $150 to $550 per repair
  • Metal (aluminum, steel, iron): $250 to $1,100 per repair
  • Post replacement (any material): $120 to $400 per post

Posts drive the bill more than boards do. That is because the old post and its concrete footing have to come out first. HomeGuide also lists smaller jobs, such as $100 to $200 to replace missing boards and $100 to $400 for gate repair. For a full breakdown by material, see our fence repair cost guide.

Option 2: Restore the whole fence

A restore suits a fence that is sound but tired. The posts are firm, yet the wood has turned gray, the stain has worn off, and a few boards are split. As a result, the fence looks older than it really is.

A typical restore has three steps:

  1. Clean it. Angi puts pressure washing at about $0.10 to $0.50 per square foot. Fixr’s range is $0.30 to $0.40 per square foot.
  2. Fix the weak spots. Swap out split boards, tighten loose rails and reset any leaning post.
  3. Stain or seal it. Angi lists $4 to $14 per linear foot for one side. Staining both sides adds about 80% to that price.

Timing matters too. Fixr notes that you can stain about 48 hours after washing, once the wood has dried. After that, plan to re-stain every few years. Our cost to stain a fence guide covers stain types and DIY costs in more detail.

A restore will not save a fence with rotten posts, though. Fresh stain on a failing frame only hides the problem for a season or two.

Option 3: Replace the whole fence

Replacement makes sense when the damage is spread across the fence, not just in one spot. In that case, paying for repair after repair often costs more than a new fence over a few years.

Installed prices per linear foot for 2026 (6 ft unless noted) look like this:

Material Installed price per linear foot (2026)
Chain link $9 to $30
Wood $20 to $60
Vinyl $30 to $60
Aluminum $25 to $75
Composite $45 to $95
Wrought iron $50 to $85

Source: Fence Guides 2026 rate sheet (HomeGuide, Angi, Trex). See all materials on our fence cost by type page.

Also, ask whether the quote includes removal of the old fence. If it does not, budget about $4 to $10 per linear foot for tear-out and haul-away. A new gate, if you need one, adds roughly $400 to $1,200. For wood options and grades, read our wood fence cost guide.

Repair, restore or replace? The 20% rule

Angi says many fence pros use a “20% rule.” In short, if 20% or more of an aging fence needs repair, replacing the whole fence is usually the better long-term choice. Angi also says that if more than 30% of a single post or panel is rotten, you should replace that piece before the rot spreads.

To use the rule, count your posts first. Posts usually sit 6 to 8 feet apart, so a 150-foot fence has roughly 20 of them. If four or more are rotten, loose or leaning, you are at the 20% mark.

Next, look at the age of the fence. Angi notes that the average fence lasts about 15 to 20 years, and less for untreated wood. So an older fence with widespread damage is a strong case for replacement. On the other hand, a younger fence with one bad section is a clear repair job.

Here is a quick guide:

  • Repair if the damage is in one or two places and the rest of the fence is solid.
  • Restore if the frame is sound but the boards look worn, gray or blotchy.
  • Replace if 20% or more needs work, several posts lean, or the fence is near the end of its life.

Worked example: fence renovation cost for 150 feet

This is our own arithmetic, using the rate sheet above. It is a guide, not a quote. Imagine a 150-foot, 6-foot wood privacy fence with about 20 posts. Three posts are rotten, and a few boards are missing.

Route How we worked it out Estimated cost
Repair only 3 posts x $120 to $400, plus $100 to $200 for boards $460 to $1,400
Restore (one side) Wash 900 sq. ft. x $0.10 to $0.50 = $90 to $450; stain 150 ft x $4 to $14 = $600 to $2,100 $690 to $2,550
Repair + restore The two rows above added together $1,150 to $3,950
Full replacement Removal 150 ft x $4 to $10 = $600 to $1,500; new fence 150 ft x $20 to $60 = $3,000 to $9,000 $3,600 to $10,500

Source: our own arithmetic from the Fence Guides 2026 rate sheet and Angi staining and washing ranges.

Three bad posts out of 20 is 15%, so this fence sits under the 20% line. Therefore, repair plus restore is the sensible choice here. However, if six posts were failing, the gap to a new fence would shrink fast, and replacement would start to look like better value.

Fence renovation cost FAQs

Is it cheaper to repair or replace a fence?

Repair is almost always cheaper upfront. A single repair usually costs $250 to $750, while a new 150-foot wood fence can run $3,000 to $9,000. Still, replacement wins once 20% or more of the fence needs work.

How much does it cost to restore an old wood fence?

For a 150-foot fence, washing and staining one side costs roughly $690 to $2,550 by our arithmetic. Then add any board or post repairs. Staining both sides adds about 80% to the stain portion.

What adds the most to fence renovation cost?

Posts and gates add the most. Each new post costs $120 to $400, and a new gate costs about $400 to $1,200. Also, tight access, rocky soil and tall fences push labor up.

Can I renovate a fence myself?

Yes, for cleaning, staining and swapping boards. Renting a pressure washer and buying stain costs far less than hiring a pro. Setting posts in concrete is harder, though, so many owners hire out that part.

How long will a renovated fence last?

It depends on the posts. With sound posts and fresh stain, a wood fence can keep going for years. Even so, you will need to re-stain every few years to keep it that way.

Ready to price your own project? Run your numbers in the calculator above, or compare local quotes through our fence estimates page.

Compare free quotes from local fence installers

Free, no obligation.

Get fence quotes

How we got these numbers

Installed prices, repair ranges, removal and gate costs come from the Fence Guides 2026 rate sheet. We built that sheet from current HomeGuide and Angi cost guides, and we use the same figures in our calculator and cost pages. Staining and pressure washing ranges come from Angi and Fixr. The 20% rule and lifespan figures come from Angi. Finally, the worked example is our own arithmetic.

Sources:

Prices last checked November 2026.

Compare other fence costs

Typical installed price per linear foot for a 6 ft fence.

Fence repair costsCost to stain a fenceAll fence types & prices →

About the authors

Written by

Rob Eddy

Rob Eddy is a home improvement expert who writes the Fence Guides cost guides. He has carried out several renovations of his own and works with local contractors to gather the prices and quotes our estimates are built on.

Reviewed by

William Johnson

William Johnson is a home improvement expert who reviews our guides before they are published. He has completed several home renovations and works with local contractors to check our prices against real quotes.

Prices are a guide: always compare quotes from local, licensed contractors. About Fence Guides · How we make money

Ready to price your fence?

Compare free quotes from up to 4 local fence installers. No obligation.

More fence guides

Get free fence quotes